Skip to main content
Juuust Right Plan
AC Installation in Hanover, MD
If you take care of your HVAC system…
Your HVAC system will take care of your home’s comfort!
Average life span? Easy! Who knows if you never get it serviced. HVAC systems will last almost twice as long and be more energy efficient if they are taken care of routinely.

What’s Included in the Beltway Service Plan?

  • Bi-Annual Check & Clean
  • Priority Service
  • 10% off all repairs and services
  • Extended warranties
  • Loyalty credit

What’s included during maintenance:

  • We clean outdoor coils with water by removing the top and back flushing
  • We clean the indoor coils by brushing off the surface dirt
  • We clean the blower motor and blower wheel by brushing off the surface dirt
  • We clean and flush the condensate drain and/or condensate pump
  • Wiping down indoor and outdoor units with custom cleaner/wax to make the system shine as well as not be faded quickly by the sun
  • We will clean any debris away from the outdoor and indoor unit

All Maintenace Services:

Cooling Maintenance:
  • Check Outdoor Coil Condition Clean Outdoor Coil with Water Check Outdoor Fan Blades
  • Check Electrical Connections Tighten Electrical Connections Check Amp Draw on Outdoor Fan Motor
  • Check Amp Draw on Compressor Check Mega Ohm Readings
  • Check High-side Compressor Pressure
  • Check Low-side Compressor Pressure
  • Check Subcooling/superheat For Proper Refrigerant Charge
  • Tighten Service Caps
  • Clean Debris from Outdoor Unit Check Capacitor
  • Check Control Board
  • Check Contactor
  • Check Drain for Blockages
  • Check Condensate Pump
  • Lubricate all motors and check
Heating Maintenance:
  • Check T-stat Calibration and Operation Check Furnace Filter
  • Check for Proper Ignition
  • Clean & Check Burners (As Required) Clean & Check Pilot Assembly (When Applicable)
  • Check Flame Sensor Reading
  • Check Ignitor Resistance
  • Check & Adjust Gas Pressure
  • Check for Proper Temperature Rise Check Draft Fan Operation & Amp Draw Check Pressure Switch for Proper Operation Check All Safety Controls
  • Check Blower Motor & Blower Capacitor Clean Cabinets & Outside of Unit
  • Secure All Electrical Connections
  • Check Flue for Obstructions/Clean Drain Lines Inspect Heat Exchanger for Cracks or Corrosion
  • Check Carbon Monoxide in Exhaust Check Exhaust Outside for Obstructions Duct & Dryer Vent Inspection
  • Water Heater Inspection
Plumbing Maintenance:
  • Inspect for leaks, cracks, or corrosion
  • Check water pressure and flow
  • Look for signs of rust or mineral buildup
  • Ensure insulation on exposed pipes (to prevent freezing)
  • Test all faucets (kitchen, bathroom, utility sinks
  • Test showerheads for water flow and leaks
  • Inspect caulking and grout to prevent water damage
  • Inspect water heater and connections for leaks or rust
  • Inspect hose bibs/spigots for leak
  • Look for water stains on walls, ceilings, or floors
  • Inspect sump pump (if present)
  • Confirm proper drainage around the property

What’s not included during maintenance:

Any and all chemical cleanings are not covered or performed during the bi-annual check and clean. For example, if the outdoor coil is so clogged and dirty that water alone is not enough to clean it and we have to use a chemical cleaner, this will not be covered within the contract.

Sign Up Online

Maintenance Plan Form

"*" indicates required fields

This field is for validation purposes and should be left unchanged.
Address*

Book Online

"*" indicates required fields

This field is for validation purposes and should be left unchanged.